Views:0 Author:Site Editor Publish Time: 2021-09-14 Origin:Site
The bike rack carrier is a device for fixing a bicycle on a vehicle and carrying it. So, do you know how should it be installed? Next are some simple instructions.
Here is the content:
l Assemble pin nut and self-locking handle
l Install the T-bolt and self-locking handle on the base
l Install the wheel tensioner
l Install the bike rack carrier to the roof rack
Use the key to open the lock on the bike rack carrier body and remove the three self-locking handles. Insert the three cylindrical pin nuts into the pinholes of the three self-locking handles, with the screw holes facing outwards.
Note that there are two front and rear bases on the main body of the bike rack carrier. The curved end of the bike rack carrier body is the front end, and the front base is relatively large. Two self-locking handles and long T-bolts (61mm) need to be installed. The rear base is a thin iron plate, and a self-locking handle and a short T-bolt (35mm) are installed in the middle hole. When installing, the self-locking handle of the bike rack carrier is placed on the base vertically, and the T-shaped bolt is passed through the round hole of the base and screwed into the pine nut in the self-locking handle.
With the smooth side of the wheel tensioning belt facing inward, insert it from bottom to top into the lock under the wheel tray without inserting it to the end. Leave a few centimeters below the tray to adjust the thickness of the wheel. At this point, the bike rack carrier is assembled.
Make sure that the self-locking handle of the bike rack carrier is open (upright), push the T-bolt of the bike rack carrier into the T-shaped groove on the top of the luggage rack, and adjust the position of the bike rack carrier so that it is parallel to the body. Tighten the three self-locking handles clockwise until they can be locked (just enough force to level), level the handles, and the bike rack carrier will be locked. Use the key to lock the self-locking handle on the outer side of the front base of the bike rack carrier. Cut the rubber sealing strip of the roof rack into several sections, adjust the size, and cover the exposed part of the T-slot again, and then use the key to mirror the handle of the roof rack.
Suzhou Pioneer Vehicle Co., Ltd. is located in Suzhou, China, covering an area of more than 7,000 square meters, and has been engaged in bike rock carriers for more than 20 years. Before leaving the factory, all products undergo several long-term fish studies. If you are interested in related work or our cost-effective products, you can contact us. Our website is https://www.vanbikestorage.com/.
Bike Rack Carrier has many applications, corresponding products such as Bike Rack for Car, Bike Rack for Truck and so on.